How do I set up Beosound Essence Remote for use with Beosound Moment?

Moment.jpg

If you have purchased a Beosound Essence Remote to be used with Beosound Moment, you need to change the mode setting of the remote.

Change the mode setting of Beosound Essence Remote:

1. Use a small pin, such as a straightened paper clip to press the mode ‘button’.

blobid0.jpg

2. Now the green LEDs on the front of Beosound Essence Remote show the actual mode setting of Beosound Essence Remote.

3. While the green LEDs light up, press the < or > buttons to step between the IR modes. Select mode ‘1’ to operate Beosound Moment (In mode ‘1’ LED B is on, the remaining LEDs are off)

When mode ‘1’ is displayed, wait approximately 5 seconds until the LEDs switch off, to store it.

blobid1.jpg

In mode ‘1’ LED B is on, the remaining LEDs are off.

blobid2.png

 


Was this article helpful?

Thank you for the feedback!



Ready to help you 24/7

6

Our support site is under construction

We are creating a brand-new support section for you, and this particular product group is not yet available, unfortunately.

For support of these products, we refer to the support pages accessed via the link below.

Chat support under construction

We are working on providing you with a brand-new feature.
If you need assistance with your product, please contact our service team through the contact form or by calling us.
Virtual Assistant
X
Powered by Zendesk