What do the indicator lights on Beoplay A6 mean?

BPa6.jpg

The light indicator shown below can display the following behaviours:

mceclip0.png

Network / Bluetooth indicator 
 Network
White (flashing)  Starting up network module
White (solid) Connected to network, network signal is strong
Orange (solid) Connected to network, network signal is weak
Orange (flashing) In wireless setup mode
Red (solid) Not connected to the network
Red (flashing) Slow flashing:
When the product indicator is also flashing red at the same time. A software update is in progress. Do not operate the product or switch it off.

Fast flashing:
Network error.
Bluetooth
Blue (flashing) Bluetooth pairing mode (ready to pair a device)
Blue (Solid briefly) Pairing successful
Red (solid briefly) Pairing unsuccessful

mceclip1.png

Product indicator 
White (flashing) Product is starting up
Off In standby or switched off
In standby or switched off The product is receiving a remote control command
Red (solid briefly) During factory reset
Red (solid) Not connected to a network
Red (flashing) Slow flashing:
When the network/Bluetooth indicator is also flashing red at the same time. a software update is in progress. Do not operate the product or switch it off.

Fast flashing:
Critical firmware error. Disconnect your product from the mains and reconnect. If the problem persists, contact your Bang & Olufsen retailer.
Orange (flashing) Product is overheating and needs time to cool down

Was this article helpful?

Thank you for the feedback!



Ready to help you 24/7